DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
- Single-Port 100BASE-FX fast Ethernet uplink
module
- Compliant with IEEE802.3u
- Link and Act(ivity) LED
- Supports forced 100M, full-duplex and IEEE802.3
compliant flow control for full-duplex
- SC Type connector good over 15km distance
Figure 2- 7. DEM-201FL Optional Module
To install the modules, follow the simple steps listed below.
CAUTION: Before adding the optional module, make sure to disconnect all power
sources connected to the Switch. Failure to do so may result in an electrical shock,
which may cause damage, not only to the individual but to the Switch as well.
At the front of the Switch to the right is the slot for the optional module, as shown in Figure 2-7 and Figure 2-8. This slot
should be covered with a faceplate that can be easily removed by loosening the screws and pulling off the plate.
Optional Module Slots
Figure 2- 8. Optional Module slots at the front of the DES-3018
Optional Module Slots
Figure 2- 9. Optional Module slot at the front of the DES-3026
Take the module and gently slide it in to the available slot at the front of the Switch until it reaches the back, as shown in
the following figure. At the back of the slot is a plug that must be connected to the module. Gently, but firmly push in on
the module to secure it to the Switch. The module should fit snugly into the corresponding receptor.
10
To Next Page
Loading...
