DES-3550 Layer 2 Fast Ethernet Switch
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-6> {master_port <port> | ports
<portlist> | state [enable | disable]
Description This command allows you to configure a link aggregation group that was created
with the create link_aggregation command above. The DES-3550 supports
link_aggregation cross box which specifies that link aggregation groups may be
spread over multiple switches in the switching stack.
Parameters
group _id <value 1-6> − Specifies the group ID. The Switch allows up to 6 link
aggregation groups to be configured. The group number identifies each of the
groups.
master_port <port> − Master port ID. Specifies which port (by port number) of the
link aggregation group will be the master port. All of the ports in a link aggregation
group will share the port configuration with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the link
aggregation group.
state [enable | disable] − Allows you to enable or disable the specified link
aggregation group.
Restrictions Only administrator-level users can issue this command. Link aggregation groups
may not overlap.
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 with group members ports 5-7 plus port 9:
DES-3550:4#config link_aggregation group_id 1 master_port 1 ports 5-7, 9
Command: config link_aggregation group_id 1 master_port 1 ports 5-7, 9
Success.
DES-3550:4#
153
To Next Page
Loading...
