DES-3550 Layer 2 Fast Ethernet Switch
show dhcp_relay
Purpose Used to display the current DHCP/BOOTP relay configuration.
show dhcp_relay {ipif <ipif_name 12>}
Description This command will display the current DHCP relay configuration for the Switch, or
if an IP interface name is specified, the DHCP relay configuration for that IP
interface.
Parameters ipif <ipif_name 12> The name of the IP interface for which to display the current
DHCP relay configuration.
Restrictions None.
Syntax
Example usage:
To show the DHCP relay configuration:
DES-3550:4#show dhcp_relay
DHCP/BOOTP Relay Status : Enabled
Command: show dhcp_relay
DHCP/BOOTP Hops Count Limit : 2
DHCP/BOOTP Relay Time Threshold : 23
DHCP Relay Agent Information Option 82 State : Enabled
DHCP Relay Agent Information Option 82 Check : Enabled
DHCP Relay Agent Information Option 82 Policy : Replace
Interface Server 1 Server 2 Server 3 Server 4
------------ --------------- --------------- --------------- --------------
System 10.58.44.6
DES-3550:4#
181
To Next Page
Loading...
