D-Link DES-3550 - Page 186

DES-3550 Layer 2 Fast Ethernet Switch
Example usage:
To show a single IP destination of the DHCP relay configuration:
DES-3550:4#show dhcp_relay ipif System
Command: show dhcp_relay ipif System
Interface Server 1 Server 2 Server 3 Server 4
------------ --------------- --------------- --------------- --------------
System 10.58.44.6
DES-3550:4#
enable dhcp_relay
Purpose Used to enable the DHCP/BOOTP relay function on the switch.
Syntax enable dhcp_relay
Description This command is used to enable the DHCP/BOOTP relay function on the switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable DHCP relay:
DES-3550:4#enable dhcp_relay
Command: enable dhcp_relay
Success.
DES-3550:4#
182