DES-3550 Layer 2 Fast Ethernet Switch
config traffic_segmentation
Purpose Used to configure traffic segmentation on the Switch.
Syntax
config traffic_segmentation [<portlist>] forward_list [null |
<portlist>]
Description The config traffic_segmentation command is used to configure traffic
segmentation on the Switch.
Parameters
<portlist> − Specifies a port or range of ports that will be configured
for traffic segmentation.
forward_list − Specifies a range of ports that will receive forwarded
frames from the ports specified in the portlist, above.
Restrictions Only administrator-level users can issue this command.
null − No ports are specified •
• <portlist> − Specifies a range of ports for the forwarding
list. This list must be on the same Switch previously
specified for traffic segmentation (i.e. following the
<portlist> specified above for config traffic_segmentation).
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DES-3550:4# config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DES-3550:4#
214
To Next Page
Loading...
