DES-3550 Layer 2 Fast Ethernet Switch
show traffic_segmentation
Purpose Used to display the current traffic segmentation configuration on the
Switch.
Syntax
show
traffic_segmentation <portlist>
Description The show traffic_segmentation command is used to display the
current traffic segmentation configuration on the Switch.
Parameters
<portlist> − Specifies a port or range of ports for which the current
traffic segmentation configuration on the Switch will be displayed.
Restrictions The port lists for segmentation and the forward list must be on the
same Switch.
Example usage:
To display the current traffic segmentation configuration on the Switch.
DES-3550:4#show traffic_segmentation
Command: show traffic_segmentation
Traffic Segmentation Table
Port Forward Portlist
---- ----------------------------
1 1-50
2 1-50
3 1-50
4 1-50
5 1-50
6 1-50
7 1-50
8 1-50
9 1-50
10 1-50
11 1-50
12 1-50
13 1-50
14 1-50
15 1-50
16 1-50
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
17 1-50
18 1-50
215
To Next Page
Loading...
