DES-3550 Layer 2 Fast Ethernet Switch
delete arpentry
Purpose Used to delete a static entry into the ARP table.
Syntax
delete arpentry {[<ipaddr> | all]}
Description This command is used to delete a static ARP entry, made using the
create arpentry command above, by specifying either the IP address
of the entry or all. Specifying all clears the Switch’s ARP table.
Parameters
<ipaddr> − The IP address of the end node or station.
all − Deletes all ARP entries.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To delete an entry of IP address 10.48.74.121 from the ARP table:
DES-3550:4#delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
Success.
DES-3550:4#
233
To Next Page
Loading...
