DES-3550 Layer 2 Fast Ethernet Switch
When autoconfig is enabled and the Switch is rebooted, the normal login screen will appear for a few moments while the
autoconfig request (i.e. download configuration) is initiated. The console will then display the configuration parameters as
they are loaded from the configuration file specified in the DHCP or TFTP server. This is exactly the same as using a
download configuration command. After the entire Switch configuration is loaded, the Switch will automatically “logout” the
server. The configuration settings will be saved automatically and become the active configuration.
Upon booting up the autoconfig process is initiated, the console screen will appear similar to the example below. The
configuration settings will be loaded in normal order.
DES-3550 Fast Ethernet Switch Command Line Interface
Firmware: Build 3.01-B20
Copyright(C) 2000-2004 D-Link Corporation. All rights reserved.
DES-3550:4#
DES-3550:4#
DES-3550:4#download configuration 10.41.44.44 c:\cfg\setting.txt
Command: download configuration 10.41.44.44 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
The very end of the autoconfig process including the logout appears like this:
DES-3550:4#disable authen_policy
Command: disable authen_policy
Success.
DES-3550:4#
DES-3550:4##-------------------------------------------------------------------
DES-3550:4## End of configuration file for DES-3550
DES-3550:4#
**********
* Logout *
**********
71
To Next Page
Loading...
