• Name: A suitable name for the rule, for example Queries_if2
• Type: Query
• Action: Proxy
• Output: if2 (this is the relay interface)
3. Under Address Filter enter:
• Source Interface: wan
• Source Network: UpstreamRouterIp
• Destination Interface: core
• Destination Network: auto
• Multicast Source: 192.168.10.1
• Multicast Group: 239.192.10.0/24
4. Click OK
Advanced IGMP Settings
There are a number of IGMP advanced settings which are global and apply to all
interfaces which do not have IGMP settings explicitly specified for them.
4.6.4. Advanced IGMP Settings
The following advanced settings for IGMP can be found in the Web Interface by going to:
Network > Routing > Advanced Multicast Settings
Auto Add Multicast Core Route
This setting will automatically add core routes in all routing tables for the multicast IP address range
224.0.0.0/4. If the setting is disabled, multicast packets might be forwarded according to the default
route.
Default: Enabled
IGMP Before Rules
For IGMP traffic, by-pass the normal IP rule set and consult the IGMP rule set.
Default: Enabled
IGMP React To Own Queries
The firewall should always respond with IGMP Membership Reports, even to queries originating
from itself. Global setting on interfaces without an overriding IGMP Setting.
Default: Disabled
IGMP Lowest Compatible Version
4.6.4. Advanced IGMP Settings Chapter 4. Routing
237
To Next Page
Loading...
