5 Configuration D-Link DGS-1100-06/ME User Manual
Click Apply to create a new SNMP host, Delete to remove an existing host.
System > SNMP Settings > SNMP Engine ID
The Engine ID is a unique identifier used to identify the SNMPv3 engine on the Switch.
Input the Engine ID then click Apply to apply the changes and click Default resets to default value.
Figure 5.28 – System > SNMP Settings > SNMP Engine ID
System > SNMP Settings > SNMP Trap Settings
The SNMP Trap Settings page provide user to Specify whether the device can send SNMP notifications.
Figure 5.29 – System > SNMP Settings > SNMP Trap Settings
SNMP Authentication Traps: Specifies the device to send authentication failure notifications.
System Device Bootup: System boot-up information.
Fiber Port Link Up / Link Down: Fiber port connection information.
Twisted Pair Port Link Up / Link Down: Twisted pair port connection information.
Port Security Violation: Information of Port Security Violation.
Loopback Detection occurring / recovery: Specify the device to send SNMP Trap when Loopback
Detection occurring and recovery.
Click Apply for the changes to take effect.
System > User Accounts
The User Accounts page provides user to control user privileges. To add a new user by typing in a User
Name, Password and retype the same password in the Confirm Password and choose the level of
privilege(Admin, Operator or User) from the Access Right drop-down menu, then click the Apply button.
User can modify existing user account in the User Account Table. To change the password, type in the Old
Password, New Password and retype it in the Confirm New Password entry field and select the Encrypt,
then click the Edit button. To delete the user account, click on the Delete button.
Figure 5.30– System > User Accounts
To Next Page
Loading...
