5 Configuration D-Link DGS-1100-06/ME User Manual
28
System > MAC Address Aging Time
The MAC Address Aging Time page specifies the length of time a learned MAC Address will remain in the
forwarding table without being accessed (that is, how long a learned MAC address is allowed to remain idle).
To change this, type in a different value representing the MAC address age-out time in seconds.
Figure 5.31 – System > MAC Address Aging Time
MAC Address Aging Time (10-600): Specifies the aging time of MAC address on the Switch. The range is
from 10 to 600, and the default is 300 seconds.
System > ARP Aging Time Settings
The ARP Aging Time Settings page provides user to globally set the maximum amount of time, in minutes,
and Address Resolution Protocol (ARP) entry can remain in the Switch’s ARP table, without being accessed,
before it is dropped from the table.
Figure 5.32 – System > ARP Aging Time Settings
ARP Aging Time (0-65535): Specifies the ARP aging time on the Switch. The range is from 0 to 65535 with
a default setting of 5 minutes.
System > Web Settings
The WEB State is Enabled by default. If user choose to disable this by selecting Disabled, user will lose the
ability to configure the system through the web interface as soon as these settings are applied.
Figure 5.33– System > Web Settings
Port (1-65535): Specifies the Port number. The range is between 1 and 65535 with the well-known default is
80.
System > Telnet Settings
Telnet configuration is Enabled by default. If user does not want to allow the Telnet configuration, they only
need to disable the Telnet State.
Figure 5.34 – System > Telnet Settings
Port (1-65535): The TCP port number. TCP ports are numbered between 1 and 65535. The well-known TCP
port for the Telnet protocol is 23.
To Next Page
Loading...
