D-Link DGS-1100-06/ME - Monitoring > Port Utilization

5 Configuration D-Link DGS-1100-06/ME User Manual
60
Figure 5.95 – Security > Access Authentication control > Authentication Server Group
Simply enter a group name of no more than 15 alphanumeric characters to define the user group to add.
After clicking Apply, the new user-defined group will be displayed in the Server Group table. Here, it can be
configured as the user desires.
The Switch has two built-in Authentication Server Groups that cannot be removed but can be modified. To
modify a particular group, click Edit button, which will then display the following window.
Figure 5.96 – Security > Access Authentication control > Authentication Server Group-Edit
Select Group Name, Protocol and IP address then click Add to implement the changes.
NOTE: The user must configure Authentication
Server Hosts using the Authentication Server
Hosts page before adding hosts to the list.
Authentication Server Hosts must be configured
for their specific protocol on a remote centralized
server before this function can work properly.
Security > Access Authentication Control > Authentication Server
This Authentication Server page will set user-defined Authentication Server Hosts for the RADIUS security
protocols on the Switch. When a user attempts to access the Switch with Authentication Policy enabled, the
Switch will send authentication packets to a remote RADIUS server host on a remote host. The RADIUS
server host will then verify or deny the request and return the appropriate message to the Switch. The
maximum supported number of server hosts is 16.
Figure 5.97 – Security > Access Authentication control > Authentication Server
To add an Authentication Server Host:
IP Address: Select IPv4 or IPv6 and enter the IP address.