DIR-100 Triple Play Router
Rear Panel
Connect the power adapter cord and network cables on the rear panel. The reset button is also located on the
back of the device.
Note: The computer used to manage the computer must be connected to one
of the NAT ports (3 or 4) or it will not be able to connect to the Router’s
management software.
Note: For multiple function on DIR-100, the “NAT” & “VLAN” words will not
be seen on the real device.
LAN Ports
NAT (#1 and #1)
VLAN (#3 and #4)
Connect two NAT ports (3&4) to Ethernet devices such as switches,
computers and wireless access points. The computer used to manage the
Router must be connected to ports 3or 4 (NAT port). VLAN ports (1&2) are
specially configured for premium IP services such as video on demand
and VoIP.
WAN
Connect to broadband device such as an ADSL or cable modem.
Power Adapter
Insert power adapter into receptacle and plug into a suitable power
source.
Reset Button
Use this to reset the device to default settings including IP settings
and administrator access information.
Note: All ports (LAN and WAN) are Auto-MDIX. All ports also automatically connect
with straight-through or crossover CAT5 or better Ethernet cable.
Power Adapter
WAN Port
Reset
Button
LAN Ports
Connect NAT ports (3&4) to
Ethernet devices, VLAN ports (1&2)
to audio/visual network hardware.
To Next Page
Loading...
