D-Link DIR-505 - Wi-Fi Hot Spot Setup

116D-Link DIR-505 User Manual
Section 3 - Conguration
Save to Local
Hard Drive:
Upload from
Local Hard Drive:
Restore to
Factory Default:
Reboot the
Device:
Use this option to save the current repeater conguration
settings to a le on the hard disk of the computer you
are using. Click the Save button. You will then see a le
dialog where you can select a location and le name for
the settings.
Use this option to load previously saved access point
conguration settings. Click Browse to nd a previously
saved conguration le. Then, click the Upload Settings
button to transfer those settings to the repeater.
This option will restore all conguration settings back
to the settings that were in eect at the time the access
point was shipped from the factory. Any settings that
have not been saved will be lost, including any rules that
you have created. If you want to save the current access
point conguration settings, use the Save button above.
Note: Restoring the factory default settings will not reset
the Wi-Fi Protected Status to Not Congured.
Click to reboot the repeater.
System