D-Link DIR-505 - LAN Setup

132D-Link DIR-505 User Manual
Section 3 - Conguration
LAN Setup
This section will allow you to change the local network settings of the access point and to congure the DHCP settings.
Device Name:
LAN Connection
Type:
IP Address:
Subnet Mask:
Local Domain
Name:
DHCP Server
Settings:
Enter the Device Name of the AP. It is recommended to
change the Device Name if there is more than one D-Link
device within the subnet.
Dynamic IP (DHCP) automatically obtains an IP address
on the LAN/private network.
Enter the IP address of the access point. The default IP
address is 192.168.0.1. If you change the IP address, once
you click Save, you will need to enter the new IP address
in your browser to get back into the conguration utility.
Enter the Subnet Mask assigned by your ISP.
Enter the local domain Name.
Congure the built-in DHCP server to assign IP addresses
to the computer on your network.