36D-Link DIR-505 User Manual
Section 3 - Conguration
Select Router or Access point from the drop-down menu.
Select Dynamic IP (DHCP) to obtain IP Address information
automatically from your ISP. Select this option if your ISP does
not give you any IP numbers to use. This option is commonly
used for cable modem services.
The Host Name is optional but may be required by some ISPs.
Leave blank if you are not sure.
Check the box if you are having problems obtaining an IP
address from your ISP.
Enter the Primary and secondary DNS server IP addresses
assigned by your ISP. These addresses are usually obtained
automatically from your ISP. Leave at 0.0.0.0 if you did not
specically receive these from your ISP.
Maximum Transmission Unit - you may need to change the
MTU for optimal performance with your specic ISP. 1500 is
the default MTU.
The default MAC Address is set to the Internet port’s physical
interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address
unless required by your ISP. You can use the Copy Your PC’s
MAC Address button to replace the Internet port’s MAC
address with the MAC address of your Ethernet card.
Operation Mode:
My Internet
Connection:
Host Name:
MAC Address:
Primary/Secondary
DNS Server:
MTU:
Use Unicasting:
Manual Internet Setup
Dynamic (Cable)
To Next Page
Loading...
