D-Link DIR-518L - Page 85

81D-Link DIR-518L User Manual
Section 4 - Conguration
Status:
DHCP IP Address
Range:
DHCP Lease Time:
Always Broadcast:
Slide to enable or disable the DHCP server function.
Enter the starting and ending IP addresses for the DHCP
server’s IP assignment.
Note: If you statically (manually) assign IP addresses to your
computers or devices, make sure the IP addresses are outside
of this range or you may have an IP conict.
The length of time for the IP address lease. Enter the Lease
time in minutes.
Enable this feature to broadcast your network’s DHCP
server to LAN/WLAN clients.
DHCP SERVER
ADVANCED SETTINGS
UPnP:
WAN Port Speed:
IPv4 Multicast
Streams:
IPv6 Multicast
Streams:
Slide to enable or disable the uPnP server function.
Select Auto (10/100 Mbps), 100 Mbps, or 10 Mbps.
Enable multicasting for your IPv4 network.
Enable multicasting for your IPv6 network.