D-Link Dis-200G Series

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
145
This example shows how to display the port trust state for eth 1/0/2 to eth 1/0/5.
Switch# show mls qos interface eth1/0/2-1/0/5 trust
Interface Trust State
-------------- -----------------
eth1/0/2 trust DSCP
eth1/0/3 trust CoS
eth1/0/4 trust DSCP
eth1/0/5 trust CoS
Switch#
This example shows how to display the scheduling configuration for eth1/0/2 to eth1/0/4.
Switch# show mls qos interface Ethernet 1/0/2-4 scheduler
Interface Scheduler Method
------------ -----------------
eth1/0/2 wrr
eth1/0/3 sp
eth1/0/4 wrr
Switch#
This example shows how to display the rate limit for eth 1/0/1 to eth 1/0/5.
Switch# show mls qos interface Ethernet 1/0/1-5 rate-limit
Interface Rx Rate
------------ -----------------
eth1/0/1 No Limit
eth1/0/2 No Limit
eth1/0/3 1300 kbps
eth1/0/4 No Limit
eth1/0/5 No Limit
Switch#
28-7 show mls qos map dscp-cos
This command is used to display the DSCP to CoS map information.
show mls qos map dscp-cos
Parameters