38D-Link DSL-124 Wireless N300 ADSL2+ Modem Router User Manual
Section 4 - Conguration
PPPoE (DSL WAN/Ethernet WAN)
Channel Mode: Select PPPoE.
VPI (DSL Only): Virtual path identifier (VPI) is the virtual path between two points
in an ATM network. Its valid value is between 0 and 255. Enter the
correct VPI provided by your ISP. This option is not available for
Ethernet WAN connections.
VCI (DSL Only): Virtual channel identifier (VCI) is the virtual channel between
two points in an ATM network. Its valid value is between 32 and
65535. Enter the correct VCI provided by your ISP. This option is not
available for Ethernet WAN connections.
Encapsulation
(DSL Only):
Select the type of encapsulation your ISP uses, either Logical Link
Control (LLC) or Virtual Circuit Multiplexing (VC-Mux) This option is
not available for Ethernet WAN connections..
Enable NAPT: Check this box to enable NAT, which allows devices on your
network to share one public IP address.
Enable IGMP: Check to enable IGMP Multicast.
VLAN: Choose to either Disable or Enable the use of VLANs.
VLAN ID(1-4095): If you enabled 802.1q, enter the VLAN ID.
IP Protocol: Select the type of IP addressing: IPv4/v6, IPv4, or IPv6.
PPP Settings: Enter your PPP authentication information.
User Name: Enter your PPPoE account username provided by your ISP.
Password: Enter your PPPoE account password provided by your ISP.
WAN CONFIGURATION
To Next Page
Loading...
