D-Link DSL-2750E - Page 74

DSL-2750E User Manual
71
Click Add to add a static route. The page shown in the following figure appears.
The following table describes the parameters of this page.
Field Description
Destination Network
Address
The destination IP address of the router.
Subnet Mask The subnet mask of the destination IP
Use Interface The interface name of the router output port.
Click Apply to save the settings.
3.3.13.2 IPv6 Static Route
Choose ADVANCED > Routing and click IPv6 Static Route. The page shown in
the following figure appears. This page is used to configure the routing
information. In this page, you can add or delete IP routes.
Click Add to add a static route. The page shown in the following figure appears.