DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
Figure 94. The page for creating a new IPIP6 connection. The IP section.
Parameter Description
IP
Obtain remote host
address automatically
Move the switch to the right to configure automatic assignment of a
remote host IPv6 address.
Type
Select an identification method for the remote host from the drop-
down list:
• Address: The remote host is identified by its IPv6 address.
• FQDN: The remote host is identified by its domain name.
The drop-down list is displayed if the Obtain remote host
address automatically switch is moved to the left.
Remote host
Enter the remote host IPv6 address if the Address value is selected
from the Type drop-down list.
Enter the remote host domain name if the FQDN value is selected
from the Type drop-down list.
The field is available for editing, if the Obtain remote host
address automatically switch is moved to the left.
Mode
An operation mode of the connection.
From the drop-down list, select the DSLite value.
Set MTU automatically
Move the switch to the right to set the maximum size of units
transmitted by the interface automatically.
Move the switch to the left to specify this parameter manually.
Upon that the MTU field is displayed.
MTU The maximum size of units transmitted by the interface.
When all needed settings are configured, click the APPLY button.
After clicking the button, the window for additional configuration of the connection opens.
Page 117 of 352
To Next Page
Loading...
