DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Installation and Connection
Connecting to PC
1. Connect an Ethernet cable between any of LAN ports located on the back panel of the router
and the Ethernet port of your PC.
2. To connect the device to a fiber optic line: connect your SFP transceiver to the SFP port,
then connect the fiber optic cable to the SFP transceiver.
3. To connect via USB modem: сonnect your USB modem to the USB port
7
located on the
back panel of the router.
!
In some cases you will need to reboot the router after connection of the USB modem.
4. To connect the device to an Ethernet line: please connect the router to the ISP's Ethernet
line only after setting the WAN port (see the WAN Remapping section, page 227) and
creating an Internet connection (see the WAN section, page 83).
5. Connect a phone cable between an FXS port of the router and the phone.
6. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
7. Turn on the router by pressing the ON/OFF button on its back panel.
Then make sure that your PC is configured to obtain an IP address automatically (as DHCP client).
7 It is recommended to use a USB extension cable to connect a USB modem to the router.
Page 25 of 352
To Next Page
Loading...
