DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
Creating PPPoE WAN Connection
On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 73. The page for creating a new PPPoE connection. The General Settings section.
Parameter Description
General Settings
Interface
A physical or virtual WAN interface to which the new connection
will be assigned.
Connection name
A name for the connection for easier identification.
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
NAT
If the switch is moved to the right, the network address translation
function for IPv4 is enabled. Do not disable the function unless your
ISP requires this.
Ping
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
RIP Move the switch to the right to allow using RIP for this connection.
Page 93 of 352
To Next Page
Loading...
