DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
On the Wi-Fi / Client page, you can configure the router as a client to connect to a wireless access
point or to a WISP. To configure the 2.4GHz band or 5GHz band, go to the relevant tab.
Figure 139. The page for configuring the client mode.
To configure the router as a client, move the Enable switch to the right. Upon that the following
fields are displayed on the page:
Parameter Description
Broadcast wireless
network 2.4 GHz /
Broadcast wireless
network 5 GHz
If the switch is moved to the left, devices cannot connect to the
router's WLAN. Upon that the router can connect to another access
point as a wireless client.
Connecting to network
A method for connecting to another access point.
Page 186 of 352
To Next Page
Loading...
