DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
On the VoIP / Alarm Clock page, you can configure the phones connected to the FXS ports of the
router as alarm clocks.
Figure 198. The VoIP / Alarm Clock page.
In the Line 1 and/or Line 2 section, move the Enable alarm clock switch to the right. Then
specify the time at which the phone should ring in the Hour and Minutes fields. In the Ring time
field, specify the signal duration. Then click the APPLY button.
!
When the router is powered off or rebooted, the system time is reset to the default value.
If you have set automatic synchronization for the system time, the internal clock of the
device will be configured after connecting to the Internet. If you have set the system time
manually, you need to set the time and date again.
Page 263 of 352
To Next Page
Loading...
