DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
Creating 6in4 WAN Connection
!
Before configuring the connection, please first register on a tunnel broker’s web site.
On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 95. The page for creating a new 6in4 connection.
Parameter Description
General Settings
Connection name A name for the connection for easier identification.
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
Ping
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
Remote host
Enter the IPv4 address of the server provided by the tunnel broker.
Client IPv6 address
Enter the IPv6 address of the router provided by the tunnel broker
(without specifying the prefix length).
Server IPv6 address
Enter the IPv6 address of the server provided by the tunnel broker
(without specifying the prefix length).
Routed IPv6 network
Enter the address of the routed IPv6 subnet (without specifying the
prefix length) provided by the tunnel broker.
Page 119 of 352
To Next Page
Loading...
