DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
Creating 6to4 WAN Connection
On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 96. The page for creating a new 6to4 connection.
Parameter Description
General Settings
Connection name
A name for the connection for easier identification.
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
Ping
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
6to4 Relay Router
The IPv4 address of the gateway which is used to transfer IPv6
packets.
Set MTU automatically
Move the switch to the right to set the maximum size of units
transmitted by the interface automatically.
Move the switch to the left to specify this parameter manually.
Upon that the MTU field is displayed.
MTU
The maximum size of units transmitted by the interface.
When all needed settings are configured, click the APPLY button.
After clicking the button, the window for additional configuration of the connection opens.
Page 121 of 352
To Next Page
Loading...
