DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
Remote port
A port of the remote host, that is used for IPsec packets exchange
during the First Phase of the connection. If the field is left blank, port
500 is used. If the field is left blank and the network address
translation (NAT) function is used for the connection, port 4500 is
used.
Pre-shared key
A PSK key for mutual authentication of the parties. Click the Show
icon ( ) to display the entered key.
Local WAN
A WAN connection through which the tunnel will pass. Select a value
from the drop-down list.
• Interface: When this value is selected, the Interface drop-
down list is displayed. Select an existing WAN connection
from the list.
• Default gateway: When this value is selected, the router uses
the default WAN connection.
Local identifier
A local identifier of the router to establish connection over IPsec with
particular hosts only. To establish connection, DVG-5402G/GF local
identifier value should correspond to the remote identifier value
specified in the settings of the remote host. Use an IP address, domain
name, or certificate CN. Optional.
Local port
A port of the router, that is used for IPsec packets exchange during the
First Phase of the connection. If the field is left blank, port 500 is used.
If the field is left blank and the network address translation (NAT)
function is used for the connection, port 4500 is used.
NAT Traversal
The NAT Traversal function allows VPN traffic to pass through the
NAT-enabled device. DVG-5402G/GF allows to forcibly encapsulate
VPN traffic in UDP packets for passing through a remote device
regardless of whether it supports address translation.
If you need to enable forced encapsulation of VPN traffic, select the
Enabled value.
If you need to disable forced encapsulation of VPN traffic, select the
Disabled value.
Page 146 of 352
To Next Page
Loading...
