DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
Clients isolation
Move the switch to the right to forbid wireless clients of this
wireless network to communicate to each other.
Enable guest network
This function is available for the additional network. Move the
switch to the right if you want the devices connected to the
additional network to be isolated from the devices and resources of
the router's LAN.
In the Security Settings section, you can change security settings of the wireless network.
By default, the WPA2-PSK network authentication type of both bands of the wireless network is
specified. WPS PIN from the barcode label is used as the network key.
Figure 131. Network authentication types supported by the router.
The router supports the following authentication types:
Authentication type Description
Open
Open authentication (with WEP encryption for wireless network
modes not supporting 802.11n or 802.11ac devices).
WEP
Authentication with a shared key with WEP encryption. This
authentication type is not available when a mode supporting
802.11n or 802.11ac devices is selected from the Wireless mode
drop-down list on the Wi-Fi / Basic Settings page.
WPA
WPA-based authentication using a RADIUS server.
WPA-PSK WPA-based authentication using a PSK.
WPA2
WPA2-based authentication using a RADIUS server.
WPA2-PSK WPA2-based authentication using a PSK.
Page 172 of 352
To Next Page
Loading...
