DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Overview
LED Mode Description
Internet
Solid green
The default WAN connection is on.
No light
• The default WAN connection is off, or
• there are no WAN connections created, or
• the device is configured as an access point or
repeater.
LAN 1-4
Solid green
A device is connected to the port of the router (for the
LAN port configured as the WAN port: the router is
connected to an Ethernet line).
Blinking green
Data transfer through the relevant LAN port.
No light
The cable is not connected to the relevant port.
WLAN 2.4G
WLAN 5G
Solid green
The router's WLAN of the relevant band is on.
Blinking green
Data transfer through the Wi-Fi network of the relevant
band.
No light
The router's WLAN of the relevant band is off.
WPS
Blinking green
Attempting to add a wireless device via the WPS
function.
No light
The WPS function is not in use.
USB
Solid green
A USB device is connected to the router's USB port.
No light
No USB device.
FXS 1-2
Solid green
The line is registered on the SIP server.
Slow blinking green
Attempting to register on the SIP server.
Fast blinking green
The receiver is off-hook, an incoming call, or talking.
No light
The line is not registered on the SIP server, because
registration is disabled or the corresponding connection
is off.
In case the Power, Internet, WPS, USB, and FXS 1-2 LEDs are blinking green at the same time,
the device is in the emergency mode. Power the device off and on. If the device is loaded in the
emergency mode again, restore the factory default settings via the hardware RESET button.
Page 18 of 352
To Next Page
Loading...
