DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
You can activate the WPS function via the web-based interface or the hardware WPS button on the
cover of the device.
To activate the WPS function via the hardware button, move the Enable WPS function with
hardware button switch to the right on the tabs of both bands. Then, with the device turned on,
press the WPS button, hold it for 2 seconds, and release. The WPS LED should start blinking. In
addition, upon pressing the button, the wireless interfaces of the device are enabled if they were
disabled before.
If you want to disable activating the WPS function via the hardware button, on the tabs of both
bands, move the Enable WPS function with hardware button switch to the left and make
sure that the WPS function is not activated via the web-based interface.
To activate the WPS function via the web-based interface, on the tab of the relevant band, click the
ENABLE WPS button.
When the WPS function is enabled, the Information section is available on the page.
Parameter Description
WPS state
The state of the WPS function:
• Configured (all needed settings are specified; these settings
will be used upon establishing the wireless connection)
• Unconfigured (after activating the WPS function, the SSID
and the encryption key will be configured automatically, the
network authentication type will be changed to WPA2-PSK).
Default PIN code
The PIN code of the router. This parameter is used when connecting
the router to a registrar to set the parameters of the WPS function.
Network name (SSID)
The name of the router's wireless network.
Network authentication The network authentication type specified for the wireless network.
Encryption
The encryption type specified for the wireless network.
Password PSK The encryption password specified for the wireless network.
UPDATE
Click the button to update the data on the page.
Page 180 of 352
To Next Page
Loading...
