DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
Enable custom
parameters
Move the switch to the right to specify additional parameters for
T.38 protocol. Upon that the Custom Parameters T.38 section is
displayed on the page.
Custom Parameters T.38
Maximal buffer
The maximum buffer size (in bytes) for data received by the router.
Rate management (TCF)
From the drop-down list, select a method for facsimile data transfer
rate management: Local or Network.
Maximal rate
From the drop-down list, select the maximum rate for facsimile data
receipt/transfer (in bauds).
Error correction mode
Move the switch to the right to enable the error correction mode.
When the switch is moved to the right, the ECC signal and ECC
data fields are available for editing.
Enable spoofing
Move the switch to the right to let the router simulate facsimile data
receipt/transfer in case of delays.
Duplicate number Specify the number of packet duplications.
Fax/Modem Passthrough
Enable fax/modem
From the drop-down list, select the Auto value to enable the Fax
Passthrough and Modem Passthrough mechanisms.
To disable the mechanisms, select the Disable value.
Codec type From the drop-down list, select a codec for data transfer.
Payload type
Payload data type.
When all needed settings are configured, click the APPLY button.
Page 279 of 352
To Next Page
Loading...
