DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
Encryption protocol
Select a method of MPPE encryption.
• No encryption: MPPE encryption is not applied.
• MPPE 40 128 bit: MPPE encryption with a 40-bit or 128-bit
key is applied.
• MPPE 40 bit: MPPE encryption with a 40-bit key is applied.
• MPPE 128 bit: MPPE encryption with a 128-bit key is
applied.
MPPE encryption can be applied only if the MS-CHAP, MS-
CHAPv2, or AUTO value is selected from the Authentication
protocol drop-down list.
Authentication
protocol
Select a required authentication method from the drop-down list or
leave the AUTO value.
Keep Alive
If the switch is moved to the right, the router sends echo requests in
order to check the connection state. After several consecutive
unanswered requests the router restarts the PPP connection. If
needed, change the interval (in seconds) between requests and the
number of unanswered requests in the LCP interval and LCP
fails fields correspondingly or leave the default values.
Dial on demand
Move the switch to the right if you want the router to establish
connection to the Internet on demand. In the Maximum idle time
field, specify a period of inactivity (in seconds) after which the
connection should be terminated.
Static IP address
Fill in the field if you want to use a static IP address to access the
Internet.
PPP debug
Move the switch to the right if you want to log all data on this PPP
connection debugging. Upon that the Debugging messages
value should be selected from the Level drop-down list on the
System / Log page (see the Log section, page 329).
Page 96 of 352
To Next Page
Loading...
