DVG-N5412SP User’s Manual SETUP
D-Link Systems, Inc. 26
SETUP → VoIP Setup
Outbound Proxy Support: Check the box to send all SIP packets to the destined outbound proxy server.
An outbound proxy server handles SIP call signaling as a standard SIP proxy server would do. Further, it
receives and transmits phone conversation traffic (media) between two communication parties. This option
tells the VoIP Router to send and receive all SIP packets to the destined outbound proxy server rather than
the remote VoIP device. This helps VoIP calls to pass through any NAT protected network without
additional settings or techniques. Please make sure your VoIP Service Provider supports outbound proxy
services before you enable it.
Outbound Proxy IP/Domain: Enter the outbound proxy’s IP address or URL.
Outbound Proxy Port: Enter the outbound proxy’s listening port.
SETUP → VoIP Setup
Enable P-Assert: Check the box to enable the caller ID protection.
Privacy Type: It is used to disguise the caller ID when queried via an ITSP/Third-Party Assertion. The
Privacy Type includes ‘user’, ‘header’, ‘session’, ‘none’, ‘critical’, ‘id’ and ‘history’.
SETUP → VoIP Setup
The rule of dialing of inviting to VoIP Service Providers may vary. That is, you have to configure different
Digit Map for different VoIP Service Providers. In this filed, you can configure individual dialing plan for each
VoIP Service Provider. The following examples introduce some cases. For general configuration, refer to
Digit Map page. Note: Press “Add” to add an entry. Don’t forget to press “Apply” which in the above
of Number Translation.
To Next Page
Loading...
Need help?
General
