D-Link DWL-2100AP Command Line Interface Reference Manual

802.11 b/g Access Point Command Line Interface Manual
10
get swPower Display Software Power Setting get swPower
get SuperG Display SuperG Feature Status of enabled or disabled get SuperG
get wlanstate Display Wireless LAN state status (enabled or disabled) get wlanstate
get shortpreamble Display Short Preamble Usage state: enabled or disabled get shortpreamble
get wirelessmode Display Wireless LAN Mode (11b or 11g) get wirelessmode
get 11gonly Display 11g Only Mode operational state of enabled or disabled get 11gonly
get antenna Display Antenna Diversity of 1, 2, or best get antenna
get sta2sta Display wireless STAs to wireless STAs connect state get sta2sta
get eth2sta Display ethernet to wireless STAs connect state get eth2sta
get eth2wlan Display Eth2Wlan Broadcast packet filter state get eth2wlan
get macaddress Display Mac Address get macaddress
get config Display Current AP Configuration Settings get config
get countrycode Display Country Code setting get countrycode
get hardware Display Hardware Revisions of WLAN Components get hardware
get diap Display DIAP State get diap
get aging Display Aging Interval in seconds get aging
get ratecontrol Display supported datarate state get ratecontrol
get supportrate Display supported datarate get supportrate
get MulticastRateControl Display Multicast Rate Control state get MulticastRateControl
get MulticastRateIndex Display Multicast Rate Index get MulticastRateIndex
get MulticastPacketControl Display Multicast Packet Control state get MulticastPacketControl
get cpuload Get CPU usage cpuload
get roguebsstype Display ROGUE AP BSS Type get roguebsstype
get roguesecurity Display ROGUE AP Security Type get roguesecurity
get roguebandselect Display ROGUE AP Band Select get roguebandselect
get accountingcfgid Display the configuration of Accounting now get accountingcfgid
get ifping Display Ping control status get ifping
get MaxMulticastPacketNumber Display Max Multicast Packet Number get MaxMulticastPacketNumber
Set Command: Function Syntax
set serviceType Set Service Type set serviceType [infrastructure: independent: any]
set apmode
Set AP Mode to Normal AP, Point to Point Bridge, Point to Multipoint
Bridge, AP Repeater, or AP Client
set apmode [ap:p2p:p2mp:p2pwithoutap: p2mpwithoutap: apr: apc]
set ssid Set Service Set ID
set ssid <SSID>
SSID should be less than 33 strings.
set ssidsuppress Set SSID Suppress Mode enable or disable set ssidsuppress [disable: enable]

D-Link DWL-2100AP Specifications

General

Frequency Band	2.4 GHz
Data Transfer Rate	54 Mbps
Security	WEP, WPA, WPA2
LAN Port	1 x 10/100Base-TX (RJ-45)
Device Type	Wireless Access Point
Form Factor	External
Data Link Protocol	IEEE 802.11b, IEEE 802.11g
Antenna Qty	1
Interface	1 x 10Base-T/100Base-TX - RJ-45
Power Supply	External power adapter
Wireless Standard	IEEE 802.11b/g
Antenna	Detachable
Compliant Standards	IEEE 802.11b, IEEE 802.11g
Encryption Algorithm	WEP, WPA, WPA2
Authentication Method	RADIUS
Features	MAC address filtering
Operating Modes	Access Point, Repeater