802.11 b/g Access Point Command Line Interface Manual
11
set remoteAP Set Remote AP's Mac Address set remoteAP <xx:xx:xx:xx:xx:xx>
set autochannelselect Set Auto Channel Selection to enable or disable set autochannelselect [disable:enable]
set rate Set Data Rate set rate [best:1:2:5.5:6:9:11:12:18:24:36:48:54]
set beaconinterval Modify Beacon Interval 20-1000 set beaconinterval [20-1000]
set dtim Set Delivery Traffic Indication Message Beacon Rate. Default is 1 set dtim [1-255]
set fragmentthreshold Set Fragment Threshold set fragmentationthreshold [256-2346]
set rtsthreshold Set RTS/CTS Threshold in bytes set rtsthreshold [256-2346f]
set power Set Transmit Power in predefined increments set power [full:half:quarter:eighth:min]
set roguestatus Set Rogue AP status set roguestatus [disable: enable]
set roguebsstypestatus Set Rogue AP BSS type status set roguebsstypestatus [disable: enable]
set roguebsstype Set ROGUE AP BSS Type set roguebsstype ['apbss' | 'adhoc' | 'both' ]
set roguesecuritystatus Set Rogue AP Security Type status set roguesecuritystatus [disable: enable]
set roguesecurity Set ROGUE AP Security Type set roguesecurity
set roguebandselectstatus Set Rogue AP Band Select status set roguebandselectstatus [disable: enable]
set roguebandselect Set ROGUE AP Band Select set roguebandselect
set radius2ndstate Set the second RADIUS Mode set radius2ndstate [disable: enable]
set SuperG Enable or Disable Super G Features set SuperG [disable: enable]
set wlanstate Select the operational state of wlan: enabled or disabled set wlanstate [disable: enable]
set shortpreamble Set Short Preamble set shortpreamble [disable: enable]
set wirelessmode Used to select the wireless mode of operation for the AP: 11g, 108g set wirelessmode [11g: 108g dynamic]
set 11gonly Only 802.11g clients will be Allowed to connect to this BSS set 11gonly [disable:enable]
set antenna Set Antenna selection of 1, 2, or best set antenna [1:2:best]
set aging Set Aging Interval set aging <seconds>
set channel Select Radio Channel of Operation set channel [1:2:3:4:5:6:7:8:9:10:11]
set diap Enable or Disable DIAP set diap [disable: enable]
set eth2wlan Enable or Disable the Eth2Wlan Broadcast packet filter feature
set eth2wlan [0:1]
Explanation: 0=disable:1=enable
set sta2sta Set wireless STAs to wireless STAs connect state (WLAN Partition) set sta2sta [disable: enable]
set eth2sta Set ethernet to wireless STAs connect state set eth2sta [disable: enable]
set ratecontrol Enable/Disable supported datarate set ratecontrol [disable:enable]
set supportrate Modify supported datarate(bit mask) set supportrate
set ifping Set ping Allowed to enable or disable set ifping [disable: enable]
set MulticastRateControl Enable or Disable Multicast Rate Control
set MulticastRateControl [0:1]
Explanation: 0=disable:1=enable
set MulticastRateIndex Set Multicast Rate Index set MulticastRateIndex [0-11]
To Next Page
Loading...
