D-Link DWL-2100AP - Access Point WEP Security Configuration

802.11 b/g Access Point Command Line Interface Manual
13
WMM
Get Command: Function Syntax
get wmm Display WMM mode status (enabled or disabled) get wmm
get wmmParamBss Display WMM EDCA parameters used by STA in this BSS get wmmParamBss
get wmmParam Display WMM EDCA parameters used by this AP get wmmParam
Set Command: Function Syntax
set wmm Enable or Disable WMM Features set wmm [disable:enable]
set wmmParamBss ac Set WMM (EDCA) parameters used by STAs in this BSS
set wmmParamBss ac [AC number] [logCwMin] [logCwMax] [aifs]
[txOpLimit] [acm]
Expanation:
AC number: 0->AC_BE
1->AC_BK
2->AC_BK
3->AC_BK
Exampble:
set wmmParamBss ac 0 4 10 3 0 0
set wmmParam ac Set WMM (EDCA) parameters used by this AP
set wmmParamBss ac [AC number] [logCwMin] [logCwMax] [aifs]
[txOpLimit] [acm] [ack-policy]
Expanation:
AC number: 0->AC_BE
1->AC_BK
2->AC_BK
3->AC_BK