D-Link DWR-118 - L2 Tp

14D-Link DWR-118 User Manual
Section 4 - Conguration
L2TP
If your ISP provided a static IP address, select Static IP, otherwise
leave this setting at the default, Dynamic IP.
Enter the IP address provided by your ISP (Static IP only).
Enter the subnet mask provided by your ISP (Static IP only).
Enter the gateway address provided by your ISP (Static IP only).
Enter the server IP address provided by your ISP (Static IP only).
Enter the L2TP username provided by your ISP.
Enter the L2TP password provided by your ISP.
Re-enter the L2TP password for verication.
Select Always on if you would like the router to never disconnect,
or Connect-on-demand to allow the router to establish a
connection to the Internet only when a device on your network
tries to access a resource on the Internet.
Enter a maximum idle time during which the Internet connection
is maintained during inactivity (if you selected Always on above,
this setting will have no eect).
Address Mode:
L2TP IP Address:
L2TP Subnet
Mask:
L2TP Gateway IP
Address:
L2TP Server IP
Address:
Username:
Password:
Verify Password:
Reconnect
Mode:
Maximum Idle
Time: