D-Link DWR-512 - Outbound Filter

40D-Link DWR-512 User Manual
Section 3 - Conguration
OUTBOUND FILTER SETTING
Select this box to Enable outbound ltering.
Select a schedule to use and copy to the specied
rule ID when you click the Copy to button. You may
select Always On or use a specic schedule that
you have dened. To create and edit schedules,
please refer to “Schedules” on page 54.
OUTBOUND FILTER RULES LIST
Here, you can select whether to Allow or Deny all outgoing
trafc except for trafc that matches the listed rules.
This identies the rule.
Specify the local IP address and then
specify the port after the colon.
Specify the remote IP address and
then the port after the colon.
Tick the checkbox to enable the specied rule.
Specify the schedule rule number.
Go back to the previous lter page.
Advance to the next lter page.
Outbound Filter
Outbound Filter:
Use Schedule Rule:
ID:
Source IP : Ports:
Destination IP : Ports:
Enable:
Schedule Rule #:
Previous Page:
Next Page:
Outbound Filter enables you to control what packets are allowed to be sent out to the Internet. The outbound lter applies to all outbound
packets. After modifying any settings, click Save Settings to save your changes.