65
IP Filtering
Entries in this table are used to restrict certain types of data packets from your local network to Internet through the Gateway. Use of such
filters can be helpful in securing or restricting your local network.
Enable IP Filtering: Enable the IP filtering feature.
Enable IPv4: Select if you are using IPv4.
Enable IPv6: Select if you are using IPv6.
Local IPv4 Address: Enter your local IPv4 address.
Remote IPv4 Address: Enter your remote IPv4 address.
Local IPv6 Address: Enter your local IPv6 address.
Remote IPv6 Address: Enter your remote IPv6 address.
Protocol: Select between UDP/TCP or both.
Comment: Leave a comment to identify your IP
filtering rule.
To Next Page
Loading...
