D-Link M32 - Page 24

20D-Link M32 User Manual
Section 3 - Conguration
MAC Address
Clone:
The default MAC address is set to the physical interface MAC address
of port 1 on Mesh Point A. You can use the drop-down menu to
replace the Internet port’s MAC address with the MAC address of a
connected client.
If you selected Static IP as the Address Mode:
IP Address: Enter the IP address provided by your ISP.
Service Name: Enter the ISP service name (optional).
Primary DNS
Server:
Enter the primary DNS server IP address assigned by your ISP.
Secondary DNS
Server:
Enter the secondary DNS server IP address assigned by your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
MAC Address
Clone:
The default MAC address is set to the physical interface MAC address
of port 1 on Mesh Point A. You can use the drop-down menu to
replace the Internet port’s MAC address with the MAC address of a
connected client.
Click Save when you are done.
PPPoE (continued)