62D-Link M32 User Manual
Section 3 - Conguration
Advanced Settings - LED Control
Status LED: Choose to enable or disable the status indicator LED on the
front panel of both Mesh Point A and the other Mesh Point(s).
When disabled, the LED will no longer light up solid white
during normal operation and will instead turn o.
The LED will still light up in the corresponding color and mode in any of
the following circumstances:
-Firmware upgrade
-Device reboot
-Establishing a WPS connection
-Weak uplink signal
-No uplink signal
Once any of the above situations has ended, the LED will briey light up
solid white and then turn o again.
Click Save when you are done.
Admin (Continued)
To Next Page
Loading...
