D-Link N150 User Manual

18D-Link DHP-1220AV User Manual
Section 3 - Conguration
Wireless Settings
The Service Set Identier (SSID) is the name of your wireless
network. Create a name using up to 32 characters. The SSID is
case-sensitive.
The auto channel selection setting can be selected to allow
this device to choose the channel with the least amount of
interference.
By default the channel is set to 1. The channel can be changed
to t the channel setting for an existing wireless network or to
customize the wireless network. If you enable Auto Channel
Selection, this option will be greyed out.
WPA/WPA2 is more secure than WEP. WEP should only be used
if you have older devices that are unable to use WPA. Use of
TKIP/AES security framework provides the optimum mix of
security and compatibility. Please refer to “What is Wireless?”
on page 55 for more information.
Choose a password that is strong. A good password uses both
letters and numbers in unpredictable places. Example bad
passwords could be password or 12345678.
Wireless
Network
Name:
Enable Auto
Channel Scan:
Wireless
Channel:
Wireless
Security Mode:
Passphrase:
The DHP-1220AV lets you customize your wireless settings for your access point. This device allows you to extend your current
network so you can roam about the house while staying connected the entire time.

D-Link N150 Specifications

General

AC input	100 - 240 V AC, 50/60 Hz
ethernet	10/100 Mbps
WLAN	Up to 150 Mbps
powerline	Up to 200 Mbps
frequency range	2.4 GHz to 2.497 GHz
operating temperature	0 to 40 °C (32 to 104 °F)
storage temperature	-20 to 65 °C (-4 to 149 °F)
humidity operation	10% to 90% non-condensing
humidity storage	5% to 95% non-condensing

Weight and Dimensions

dimensions	73 x 58 x 37 mm (2.87 x 2.28 x 1.46 inches)
weight	96 grams (3.39 ounces)