D-Link N150

29D-Link DHP-1220AV User Manual
Section 3 - Conguration
System
Save Settings To
Local Hard Drive:
Load Settings
From
Local Hard Drive:
Restore to
Factory Default
Settings:
Reboot the
Device:
Use this option to save the current DHP-1220AV conguration
settings to a le on the computer you are using. Click the Save
button. You will then see a le dialog where you can select a
location and le name for the settings.
Use this option to load previously saved DHP-1220AV
conguration settings. Click Browse to nd a previously saved
conguration le. Then, click the Upload Settings button to
transfer those settings to the DHP-1220AV.
This option will restore all conguration settings back to the
settings that were in eect at the time the DHP-1220AV was
shipped from the factory. Any settings that have not been
saved will be lost, including any rules that you have created. If
you would like to save the current DHP-1220AV conguration
settings, use the Save button above.
Click to reboot the DHP-1220AV.
This page lets you both save and delete settings on your DHP-1220AV.