Need help?Do you have a question about the dacell DN-130L and is the answer not in the manual?
General| Brand | dacell |
|---|---|
| Model | DN-130L |
| Category | Touch Panel |
| Language | English |
Details two calibration systems: actual load and rated sensor output (mV/V).
Covers setting upper/lower limits and outputting contact point signals.
Notes that setup values are memorized on flash memory, preventing data loss.
States the power requirement is AC 85 ~ 265V 50/60Hz Free voltage.
Lists precautions for installation, such as avoiding wet places, high temperature, and using proper wiring.
Advises against inputting unstable loads during calibration and pressing keys arbitrarily.
Details comparison output (HI/LO) and analog output (DC 0~10V / 4~20mA).
Lists power supply as AC 85~265V 50/60Hz free voltage.
Describes its function in measuring mode (zeroing) and setup mode (returning to measuring).
Explains its function in measuring mode (display/change lower limit) and setup mode (move cursor).
Details its function in measuring mode (display/change upper limit) and setup mode (increment value).
Describes its function in measuring mode (Hold/Cancel Hold) and setup mode (Save setup).
Identifies the main power supply wiring terminals.
Denotes the ground terminal for independent ground connection.
Specifies the CH1 Sensor Supply Voltage + connection terminal.
Specifies the CH1 Sensor Supply Voltage – connection terminal.
Specifies the CH1 Sensor Output Signal + connection terminal.
Lists critical wiring and usage precautions, including grounding and checking terminals.
Explains calibration using rated capacity and rated output from a calibration sheet.
Describes calibration by applying actual load (standard weight) to the sensor.
Details calibration using the S.CAL value without requiring standard weight.
Details how to prevent accidental operations by setting key locks.
To Next Page