Decalcification Process for Model CM24T-1
1. Put a 2 quart sauce pan on the drip tray under the
coffee dispenser to collect wash and rinse water.
2. Remove the water tank from the top of the unit.
Empty it, rinse it out, and put it back in the unit.
3. Pour a packet of Puly Baby Decalcification Powder
into a 16 ounce bottle. Fill the bottle with warm
filtered water and shake well until the powder is
dissolved.
.
5.
Pour the mixture into the water tank.
Fill the tank with filtered water until it is half full.
.
.
8.
.
10.
Pour about 20 ml of Puly Milk Liquid Detergent into
the 16 ounce water bottle again. Fill the remainder
of the bottle with filtered water.
Put the bottle in the milk compartment and insert
the milk tube into the water/detergent solution.
Push and hold the CLEAN
(decaffeinated coffee) button until
"Insert Cleanser" appears on the
display.
Push CLEAN again to immediately
start the cleaning cycle. :If the
CLEAN button is not pressed
again, the cleaning cycle will automatically start in
about 20 seconds.
Meanwhile fill a second plastic water bottle with
clean, filtered water. "Rinse" will appear on
the display. Remove the first bottle from the left
compartment and replace it with the second. Put the
milk tube into the water.
Detergent Mixture in Milk Compartment
11. When rinsing is complete, the display will read "Machine Ready".
12. Push the hot water button to rinse out the water dispenser. Wait
until water stops coming out of the dispenser.
13. Repeat step 12, four more times.
14. Remove the plastic bottle from the milk compartment and flush
the residual detergent out of the system (see facing page).
Automatic Coffee System
To Next Page
Loading...
Need help?
General
