Dacor EF48 - Service Diagnostics

daCor builT-in refrigeraTor serviCe manual
Service Test 24 – Display Temperature
Select
This test reports the temperature selection switch as read
by the board.
Pressing the Power Interrupt Button will display the
current setting.
Temperature is set for Fahrenheit
Temperature is set for Celsius
Service Test 25 – Fountain State
This test reports back the current status of the dispenser.
If the dispenser control does not change the output,
suspect data communication problems with the dispenser
control itself.
Pressing the Power Interrupt Button will indicate the
current state of the dispenser.
Dispenser is Locked
Dispenser is set for dispensing water (ho from H2O)
Dispenser is set for crushed ice
Dispenser is set for cubed ice
•
•
•
•
•
•
SERVICE
Page 3-10
daCor builT-in refrigeraTor serviCe manual
SERVICE