Do not turn the starter switch
to “START” while the engine is
running.
If the engine does not start in
10 seconds, wait 30 seconds
and repeat the starting se-
quence. Never run the starter
motor continuously for more
than 20 seconds.
Always warm up the engine
before working. Using a cold
engine will shorten its life.
If the temperature may be low-
er below -15
o
C
(5
o
F
), separate
the battery from the machine,
and keep it indoors. Then use
it when starting the engine.
STOPPING
1. Disengage any load from the en-
gine. Return the speed control le-
ver to the “IDLE” position.
2. Turn the starter switch to “OFF”
and remove the key. Return the
eng i n e sto p s olenoide t o the
“START” position for the next start.
CHECK DURING OPERA-
TION
While operating the engine, keep
checking whether all parts of the en-
gine are operating smoothly and
properly.
COOLING SYSTEM
If steam or coolant is escaping from
the overflow tube; stop the engine,
allow it to cool, and check the follow-
ing and correct as needed.
1. Check for cooling system leaks.
2. Check for obstructions that block
cooling air.
3. Clean any dirt or debris from the
radiator core. (Fins & tubes)
4. Check and adjust the fan belt ten-
sion.
5.Ensure that the system is lled to
the correct coolant level with the
proper mix of anti-freeze and wa-
ter.
6. Check the radiator cap for proper
type and condition.
IMPORTANT
(1) ECU
TE4O301A
To Next Page
Loading...
Need help?
General
