CHANGING ENGINE OIL
1. Change after initial 50 hours of op-
eration.
2. To drain the used oil, remove the
drain plug at the bottom of the en-
gine and drain the oil completely into
the oil pan. All the used oil can be
drained out easily when the engine
is still warm.
3. Fill with the new oil up to the upper
notch on the dipstick.
4. Then, change engine oil at every
200 hours of operation.
Wipe any engine oil spilled on
the equipment thoroughly.
•
(1) Oil Filter
TE4O506A
(1) Drain Plug
TE4O505A
1. When changing oil, replace the oil
lteraswell.
2. Remove the oil filter with a filter
wrench.
3.Applyathinlmofoiltothegasket
of the cartridge.
4. Screw in the c a r t r i dge with a
hand. When the gasket touches
the sealing surface, tighten the
cartridge with a hand firmly. If
tightening it using a wrench, it can
be over-tightened.
REPLACING ENGINE OIL FILTER
5. Af t er r ep l ac i ng t he o il f i lt e r,
the engine oil level is lowered.
Therefore, r un the engine for
a while and check the sealing
section for oil leakage before
checking the oil level. If necessary,
add more oil.
NOTE
To Next Page
Loading...
Need help?
General
