5
-6
CRDI ENGINE
If the engine does not start or run properly, refer to the following charts to determine the cause
and identify corrective actions.
If the cause cannot be determined, contact your DAEDONG dealer for assistance.
NOTE
ENGINE OVERHEATS
POSSIBLE CAUSES ACTIONS
1. Low coolant level
•
Check for and repair leaks. Add coolant.
2. Loose or broken fan belt
•
Adjust or replace belt as required.
3. Low oil level
•
Add water or replace coolant to achieve proper mix.
4. Anti-freeze concentration too high
•
Clean dirt and debris from radiator core and radiator guard.
5. Cooling air obstructed
•
Flush and clean system. Replace parts as required.
6. Cooling system dirty or corroded
•
Flush and clean system. Replace parts as required.
7. Defective radiator cap
•
Replace defective cap.
8. Faulty thermostat
•
Check and replace thermostat nd replace, if necessary.
9. Defective temperature gauge or
sending unit
•
Calibrate using thermometer and replace, if necessary.
10. Engine overload
•
Reduce load.
11. Leaking head gasket
•
Replace head gasket.
12. Fuel injection timing
•
Check and adjust timing.
13. Unsuitable fuel
•
Replace fuel with the clean fuel of the proper type and grade.
To Next Page
Loading...
